Tactical Command
http://www.tacticalwargames.net/taccmd/

Epic tool burned into 3mm MDF
http://www.tacticalwargames.net/taccmd/viewtopic.php?f=4&t=34011
Page 1 of 1

Author:  m_folais [ Sun Jul 14, 2019 10:40 pm ]
Post subject:  Epic tool burned into 3mm MDF

I had always printed, cut, glued the paper version to card stock, plastic, MDF. None ever lasted more than a year or so. The last few years I have been breaking manufacturer's nuts to burn or print small job lots. Most FUBAR ed the project. Until now.

The first job lot of 25 have 13 or so left. I am selling them at cost, 5USD. PM if you want one. East coast crew can get them at the next event. I will bring them to the Worlds in Scotland for the EU group. Any other groups I would ship them at cost.

Image

Image

Image

Author:  jimmyzimms [ Mon Jul 15, 2019 3:57 pm ]
Post subject:  Re: Epic tool burned into 3mm MDF

that's cool as shit. my epic is all vassal now but otherwise this is awesome

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/